Single layer tile press machine

The single-layer tile press is mainly composed of a discharge machine, a feed introduction platform, a forming host, a forming shear device, a hydraulic station, a computer control system, and other parts.

The profiled sheet formed by rolling with a single-layer tile press has the characteristics of smooth appearance, uniform ripples, high utilization rate, high degree of production automation, and good yield rate.

The single-layer tile press can produce various types of roof panels with different appearances according to production needs, and is widely used in large and medium-sized civil buildings such as factories, locomotive depots, aircraft hangars, sports venues, exhibition halls, cinemas, etc.

Characteristics of single-layer tile press:

1. High degree of production automation: adopting automatic control system, accurate control of speed, length, and positioning;

2. Good quality of formed board: smooth and beautiful appearance, uniform paint pattern;

3. The equipment spindle and pressure roller are precision machined by CNC lathe.

Debugging of single-layer tile press:

First, align the height of the four corners of the front and rear queues of the single board computer from the main frame to the upper end of the bottom axis. Then, from one row to the back, find a straight line and check if the lower axis is in a straight line. Adjust the left and right sides of the lower axis to be horizontal. Find the center of the 840 type single board computer in one row and the back row, then tighten the locking nuts on both sides. Draw a straight line in front and behind the center of the middle wheel, adjust the gap between the upper and lower axes, and then adjust the machine along the straight line.

Technical parameters of single-layer tile press:

Model: 30-280-840

Length x Width x Height: 5500mm x 1300mm x 1400mm

Whole machine weight: about 2.2 tons

Forming shaft: diameter 68mm, 45 # quenched and tempered

Forming wheel: Material 45 # forged and plated with hard chromium

Transmission mode: chain wheel, chain

Motor: 3KW

Forming rows: 13 rows

Fully automatic computer fixed length cutting system:

Pump station motor: 3KW four stage

Cutting mold: Gr12

Forming speed: 8-10m/min

Pressing thickness: 0.2-0.8mm

Compression width: 1000m